Seattle Mini Maker Faire presentation

Thanks to everyone who attended my presentation at the 2012 Seattle Mini Maker Faire on Sunday.
The presentation was an overview of creating a printed circuit board using the KiCAD suite of electronic design automation tools.

Here is a PDF of the slides I used for the presentation:
Release your hardware hacker potential with KiCAD

Also a big thanks again to DorkbotPDX PCB, Midnight Maker and Seeed Studio for the PCB samples, they were a big hit!

• DorkbotPDX PCB http://dorkbotpdx.org/wiki/pcb_order
• Midnight Maker http://www.midnightmaker.com/
• Seeed Studio http://www.seeedstudio.com/

2 Responses to “Seattle Mini Maker Faire presentation”

1. Brian says:

   June 4, 2012 at 4:37 pm

   Loved the class, definitely helped fill in some blanks. I snagged a Seeduino v3.0 PCB, do you know where I can find a BOM so I can populate the board? Some of the parts are obvious, but others, not so much.

   Reply
   • Eric says:

     June 4, 2012 at 10:14 pm

     Check Seeed Studio’s wiki here:
     http://www.seeedstudio.com/wiki/Seeeduino_v3.0

     There is a PDF of the schematic and a photo that might help.

     Reply